1, 2, or 3 Row

Track

Anodized aluminum track includes an open top and bottom to allow easy location of vertical supports and clear connection to the DuctSox below. U-Track is available for most fabric options. For use with all sizes, U-Track suspension is available for one and two row suspension options (two row required at 32” diameter and larger) and may include radius sections for elbows. Gliders are spaced every 24 inches along the length to ensure proper support. The Cord-In attachment option allows for continuous support for smaller diameter sections. The system consists of 8 foot sections of U-Track, couplers, end caps, locking cable drop supports, and Gripple quick connect devices for easy installation. Supporting hardware components are available in galvanized, 316 Stainless Steel, aluminum, or impregnated cable (for pool environments).

Cable

Simple Tension Cable is available with all fabrics and is the most economical option. For use with all sizes, cable suspension is available for one, two, and three row suspension options (two row required for systems 32" up to 60" in diameter, three row required for diameters larger than 60"). Gliders are spaced every 24 inches along the length to ensure proper support. The system consists of a cable, turnbuckle(s), and securing hardware for a simple installation. Cable components are available in galvanized, 316 Stainless Steel, and impregnated cable (for pool environments).

 

SUMMARY
Easy installation & maintenance
Lowest initial cost compared to other Suspension/Retention Systems
   
1 Row 8" - 30" diameter (203mm - 762mm)
  100% Deflation
  Disruptive noise & fabric motion at start-up
   
2 Row Up to 60” (1,524mm ) diameter
  45% Deflation
  Noticeable noise & fabric motion at start-up
   
3 Row 60” (1,524mm ) or larger diameter
  17% Deflation
  Minor noise & fabric motion at start-up

 

Tensioned Endcap

The Tensioned Endcap is an option available for 1 Row Track or Cable Suspension Systems ONLY. The Tensioned Endcap allows an installer to pull on the Endcap around its full circumference and anchor it to the Track or Cable. This improves the appearance of the Endcap and the length of the duct up to 50’ (15,240 mm). Available from 8” - 30” (203mm - 762mm) diameters. (Not available for stainless steel cable, impregnated cable, or cord-in attachment.) NOTE: For maximum aesthetics and tensioning of the entire DuctSox (especially for lengths longer than 50’ or 1,270 mm where intermediate tensioning is required), see SkeleCore FTS or Pull-Tight.